Page | 5
Cool Energy diverTech Manual v1.1 2022 ©
Section 2
Installation
The following general information describes how to install the diverTech Solar Energy Diverter.
Note: Before installing this product, read and follow all warning notices and instructions. Only a qualified /
competent person should install the diverTech solar energy diverter.
The following items are needed and are to be supplied by the installer for all inverTech installations:
1. Ensure that a suitable electrical supply cable is provided.
(2.5mm Flexible Heat Resistant Flex is recommended)
2. Connections are made inside of the heat pump electrical compartment. Conduit may be attached directly to
casing if required.
3. Local isolation must be provided in the form of a 20A double pole switch fed from a 16A MCB or a 13A fused
switch.
Mounting:
The diverTech unit should be suitably mounted to the wall using appropriate fixings.
Mounting should be at a height appropriate to allow the screen to be visible and buttons accessible.
The room where the diverTech unit is installed should be well ventilated and a minimum of a 150mm air gap
around all sides of the unit should be maintained to allow airflow for cooling.
To Next Page
Loading...