Cool-Icam CIC-150 - Macintosh Troubleshooting: Installation Errors; Macintosh Troubleshooting: Software Not Found; Macintosh Troubleshooting: Images Not Appearing; Macintosh Troubleshooting: Uploading Issues

22
For Macintosh® Users:
MAC
I hear a low “beep” when trying to
take an image.
Take your images in better light condition.
Check your lens cover is open.
Put Digital Cam CD in the CD-ROM drive.
Insufcient light.
No CD in CD-ROM drive.
If you need to change batteries, and retain the
images in your Micro C@m ’s memory, ensure you
are connected to a Mac which is turned on via the
USB cable, which will then draw power from the Mac
whilst you insert fresh batteries.
This means there is insufcient
power to upload images to your
computer.
I receive an error message when I
am installing the Digital Camera
Manager.
“STV0680 Capture”/”WWL Mac
Import” plug-in le and sTV0680
Camera Snapshots”/”WWL Mac”
folder is not found in the Programs
menu after I have installed the
driver.
Digital Camera Manager does
not load.
The installer for the Digital
Camera Manager requires the
Micro C@m be connected to
the Mac (via the USB) after the
software has been installed & the
Mac restarted.
Install the software, restart your Mac, and nally,
connect the Micro C@m to the Mac via the USB
port, then the plug-in le and folder will appear in
the Hard disk.
You have lost power to your Micro C@m by either:All the images I have taken do not
appear on the Micro C@m.
I cannot upload images to the
Mac
LCD display is ashing.
Insufcient battery power
Removing the battery without
being connected to your Mac
(turned on) via the USB cable.
Connection failure
I cannot run the USB Canera
Import / WWL Mac Import.
Black corner appears on the
images taken.
My Micro C@m LCD displays
“SE”.
I cannot access any Funhouse’s
templates.
Battery power is too low to
continue taking images.
Conict with another camera driver
capture device.
Lost corner of images. Make sure you slide the lens cover to the desired
position.
If you have any other camera installed on your
computer, remove the camera and it’s driver
completely from your system to avoid conict with
another camera or capture device.
Upload saved images immediately, then replace
battery.
Check all cables connections are secured.
If you need to change batteries, and retain the
images in your Micro C@m’s memory, ensure you
are connected to a Mac which is turned on via the
USB cable, which will then draw power from the Mac
whilst you insert fresh batteries.
Upload all images to your Mac as soon as possible.
(please refer to Battery Guidance section in User’s
Manual.)
Symptom Solution Problem
Shut down all other applications and attempt to re-
install the driver, or download the updated driver
from www.cool-icam.com and install the updated
driver.
Please also refer to the help les & User Guides that accompany the enclosed applications.
For further information and support, please visit our website: http://www.cool-icam.com.