34
Continuous water discharge
Please comply with the following instructions if you wish to install a continuous water discharge:
1. Ensure that the appliance is switched off and disconnect the power plug from the power socket.
2. Take the water tank out of the appliance.
3. You will find a hose section hanging next to the water tank which is closed at the end with a plug.
4. Remove the fastening tape and take the plug out of the hose.
5. You can now place the water tank in its initial position again and guide the hose outwards through the opening at the
bottom of the water tank provided for this purpose. Please ensure that the hose does not affect the correct position of the
water tank as otherwise you will not be able to start the appliance.
6. Now guide the free end of the hose directly to an external water discharge outlet. Make sure that the entire length of the
hose is inclined, and that it is not damaged, entangled or clogged, so that water can flow freely and without any
interruption.
7. Check regularly to ensure that the water hose is installed properly is tightly.
5
6
To Next Page
Loading...
