38
Storage
1. Please remove the water tank if you do not want to use the appliance for a long period.
2. There is a hose section with a plug at the left, next to the coiled hose for permanent discharge.
3. Remove the plug from the hose hanging vertically from it, and let the water drain into a basin place below.
4. Finally replace the plug at the hose end and replace the water tank in its initial position.
Please check the following possibilities before contacting the manufacturer or his representative:
TROUBLESHOOTING
Problem Possible cause Solution
The appliance does not start when the
key is pressed
The display flashes, the water
tank is full.
Empty the water in the water tank.
The room temperature is higher than
the set temperature (Heat mode).
Readjust the temperature.
The room temperature is lower than
the set temperature (Cool mode).
Readjust the temperature.
Inadequate cooling Windows and doors are not closed Ensure that all the windows and doors
are closed.
There are heat sources in the room. Remove the heat sources to the extent
possible.
The exhaust air pipe is not connected
or it is blocked.
Connect the pipe and ensure that it
can function properly.
To Next Page
Loading...
