Cooper Security Scantronic 9752 Update Guide

Page 2
Contents
1. INTRODUCTION..........................................................................................3
About this Manual ........................................................................................................................................3
2. Changes To Hardware................................................................................3
3. Changes To Installer Programming..........................................................3
Leading ‘0’ Now Allowed in Access Codes ..................................................................................................3
Entering and Leaving Installer Mode............................................................................................................3
Command 81 to 84 - Option 38....................................................................................................................4
Command 106: - Option 0............................................................................................................................4
Command 131: ............................................................................................................................................4
Command 141: Alert Tone On/Off ...............................................................................................................6
Command 151 to 158: Plug-by Communicator Outputs...............................................................................7
Printing the Event Log (9853 only)...............................................................................................................7
4. Changes For the End User ........................................................................7
Access Codes..............................................................................................................................................7
Downloader Calling Control Unit ..................................................................................................................8
9853, 9752, 9751 Version 5 Update Guide
This document applies to control panels using software version 5.x.x.
© Cooper Security Ltd. 2007
Every effort has been made to ensure that the contents of this book are correct. However, neither the authors nor Cooper Security
Limited accept any liability for loss or damage caused or alleged to be caused directly or indirectly by this book. The contents of this book
are subject to change without notice.
Printed and published in the UK.
Part No. 1792362

Cooper Security Scantronic 9752 Specifications

General

Brand	Cooper Security
Model	Scantronic 9752
Category	Control Unit
Language	English