How to fix no display on Cooper Surgical F9 Express Medical Equipment?
If your Cooper Surgical Medical Equipment's display is not working, there might be a few reasons. First, check if the power cable is securely tightened. If that's not the issue, the fuse might be blown, and you'll need to change it. Alternatively, if the device is battery-powered, it may have run out of power, so connect it to an AC power supply.
What to do if trouble with Ultrasound FHR Monitoring on Cooper Surgical F9 Express?
Having trouble with ultrasound FHR monitoring on your Cooper Surgical Medical Equipment? Several factors could be at play. Here's what you can do: * If the pregnant woman is obese, consider using DECG for monitoring, if available. * Adjust the ultrasound transducer's position to get a better signal. * Ensure the belt is tight enough. * Wipe off any excess ultrasound coupling gel, or add more if there's not enough. * If there are frequent fetal movements, delay the monitoring. Ask the patient to reduce movements. Change the position of the ultrasound transducer if you are inadvertently recording maternal heart rate. If the transducer is not securely placed in position, adjust its position. Use paper recommended by the manufacturer. Make sure the paper drawer is locked.
How to resolve recorder error on Cooper Surgical Medical Equipment?
If you're encountering a recorder error with your Cooper Surgical Medical Equipment, consider the following possible causes and solutions: 1. **Paper Jam:** Ensure the paper is loaded correctly and protected from moisture. 2. **Recorder Not On:** Press the PRINT key to turn on the recorder. 3. **Out of Paper:** Load more paper. 4. **Paper Drawer:** Slide the paper drawer in until both latches are locked.
What to do if having trouble with Contractions Monitoring (External) on Cooper Surgical F9 Express Medical Equipment?
If you're experiencing issues with external contractions monitoring on your Cooper Surgical Medical Equipment, here are a few things to check: * Adjust the belt if it's too tight or too loose. * Replace the belt if it has lost its elasticity. * Request the patient to reduce movements. If there are frequent fetal movements, delay the monitoring. Confirm good contact to patient skin with TOCO transducer. Change the position of TOCO transducer, if necessary, if the body pressure from uterus to TOCO transducer is far higher than the average value.
General| Brand | Cooper Surgical |
|---|---|
| Model | F9 Express |
| Category | Medical Equipment |
| Language | English |
To Next Page
