EasyManua.ls Logo

CoPilot Model A - Attaching the Canopy; Attaching the Safety Flag

CoPilot Model A
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
english | 9
Disconnect the shoulder harness clips and the seat belt buckle. Place the children
side by side on the seat. Place shoulder strap A over the first child’s right shoulder
and shoulder strap B over the first child’s left shoulder. Place shoulder strap C over
the second child’s right shoulder and shoulder strap D over the second child’s
left shoulder.
Each child’s height will determine the position of his/her
respective shoulder straps. The shoulder strap height may
be adjusted by routing the straps above (for taller chil-
dren)or through (for smaller children) the horizontal loops
E. Figure 5B. For the first child, secure shoulder straps A
and B to crotch strap 1. For the second child, secure shoul-
der strap C and D to crotch strap 2. Adjust the length of the
shoulder straps and crotch straps so that both children are
held snugly in place. The crotch straps should be adjusted so that the children do not
slide too far forward. Make sure that the shoulder straps and crotch straps are snug
and secure for the safety of the children and the stability of the trailer. Attach the
seat belt across both childrens laps.
ATTACHING THE CANOPY
Position the cover over the top of the trailer so the
reflectors are to the rear and the mesh screen window is
to the front. Fasten the cover at the bottom rear of the
trailer and work it forward until it is fully covering the
top and front of the trailer. Attach the lower rear clips to
the D-Rings to hold the rear of the cover in place. In hot
weather the front window can be rolled up and secured
with the loop straps to allow ventilation into the front of the trailer. Never use the
trailer without the front screen in place to protect your child’s face from debris and
spray from the back wheel of the bicycle.
ATTACHING THE SAFETY FLAG
A three piece safety flag is included with the trailer. It
should always be used whenever you tow the trailer. In-
sert the ends of each section into the orange connectors
to assemble, and insert into the canopy O-ring on sewn
sleeve on the rear corner of the trailer. Figure 7A.
E
5B
6A
7A

Related product manuals