67
Assembly Chart 1220/1202
partition wall A / partition wall B
16
17
Turn partition wall A (part 1) by 180° with 2
people and lift it carefully over the assembled
partition wall B (part 2) and carefully insert the
pre-assembled bolts into the holes provided.
Now tighten the 4 Maxifix housings (part 9)
using an Allen key. Screw the two connector
grub screws (part 13) into the connector
housings with light pressure from above onto
partition wall A (part 1) and tighten the grub
screws.
The Chart partition wall is now fully assembled.
Using 2 people, stand the wall up, carry it to
the predetermined place in the room and align
it to the floor with the help of the 4 levelling
glides.
GB
To Next Page
Loading...
