EM 8070 operator’s manual
PNEUMATIC HOOK-UP
The pneumatic hook-up is only necessary if the ROD and QL accessories are
present.
- The connection to the workshop’s compressed air system must guarantee a
minimum pressure of 8 bar; lower pressures might prevent correct operation of
the release cylinder, leading to difficulties in releasing the wheel from the
machine shaft.
- The union for connection to the compressed air system is of universal type and
thus no special or additional attachments are required. A high pressure rubber
hose with inside diameter 6 mm and outside diameter 14 mm must be
connected to the toothed union using the hose clamp supplied with the
machine.
SAFETY REGULATIONS
WARNING
Failure to observe these instructions and the relative danger warnings can cause
serious injury to the operator or other persons.
Do not use the machine until you have read and understood all the danger/
warning/attention notices in this manual.
This machine must be used only by qualified and authorised personnel. A
qualified operator is construed as a person who has read and understood the
manufacturer’s instructions, is suitably trained, and is conversant with safety and
adjustment procedures to be adhered to during operations. Operators are
expressly forbidden from using the machine under the influence of alcohol or drugs
capable of affecting physical and mental capacity.
The following conditions are essential:
- read and understand all the instructions on how to use the machine;
- have a thorough knowledge of the capacities and characteristics of the machine;
- keep unauthorised persons well clear of the area of operation;
- make sure that the machine has been installed in compliance with established
legislation and standards;
- make sure that all machine operators are suitably trained, that they are capable
of using the machine correctly and that they are adequately supervised during
work;
- do not touch power lines or the inside of electric motors or other electrical
equipment until the power has been disconnected;
- read this manual carefully and learn how to use the machine correctly and
safely;
- always keep this manual in a place where it can be readily consulted when
working with the machine and do not fail to refer to the manual whenever in
need of confirmation or explanations.
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page
Loading...