What to do if my Corghi ERCO HC3502 B Tyre Changers lift does not finish the lifting travel?
If the lift doesn't complete its lifting travel, several factors could be at play. First, verify that the weight doesn't exceed the lift's maximum capacity. Next, ensure that the power supply voltage is adequate. Finally, check the oil level and top it up if it's low.
What to do if there is oil leak from the Corghi ERCO HC3502 B connections?
If you notice oil leaking from the connections, the unions might be loose. Tighten them, and if the leak persists, replace the unions.
Why is it hard for my Corghi Tyre Changers lift to ascent and descend?
If the lift struggles to ascend or descend, the discharge valve YA1 might be open or damaged. Try disconnecting and cleaning the discharge valve. If it's damaged, replace it.
How to fix low synchronization of the carriages on Corghi ERCO HC3502 B Tyre Changers?
Low synchronization of the carriages can occur if the synchronization cables have different tension. Adjust the nut on the cables to correct this issue.
What to do if my Corghi ERCO HC3502 B lift is connected to the mains but does not work?
If the lift is connected but not working, and the power supply indicator light is off, check a few things. First, ensure the primary transformer mains switch is in the ON position. Next, verify that the QM emergency switch on the electrical board casing is also in the ON position. Finally, check the switch (QM) inside the electrical board and reset it if it's in the OFF position.
Why is there noise during ascent or descent of my Corghi ERCO HC3502 B?
Noise during ascent or descent may be due to mechanical parts (chain, pulley, runners) lacking lubrication. Lubricate these parts to resolve the issue.
General| Model | ERCO HC3502 B |
|---|---|
| Category | Tyre Changers |
| Operating Pressure | 8-10 bar |
| Weight | 450 kg |
| Minimum Rim Diameter | 10" |
| Power Supply | 400V |
| Air Pressure | 8 bar |
To Next Page