What to do if Corghi Tyre Changers table top will not turn in either direction?
If the table top won't turn in either direction, the reverser switch might be broken, the belt could be broken, the gear motor might be jammed, or a fuse may have blown. Try changing the reverser switch, changing the belt, changing the gear motor, or changing the fuse to resolve the issue.
What causes air leak inside Corghi A 9222 HP TI Tyre Changers?
An air leak inside the machine can be caused by an air leak in the bead breaker cock, in the table top cock. To fix this, change the cock, change the bead breaker cylinder, change the table top cylinder, or change the swivel connector.
Why does Corghi Tyre Changers bead breaker cylinder have little force and leaks air?
If the bead breaker cylinder has little force, doesn't break the bead, and leaks air, it could be due to a plugged silencer or worn cylinder gaskets. Try changing the gaskets or changing the silencer, or change the bead breaker cylinder.
What to do if Corghi Tyre Changers fuses blow when depressing the table top rotate pedal?
If the fuses blow when you depress the table top rotate pedal, the power cord might be shorted, or the motor could be shorted. Check the wires, change fuses, or change the motor to solve this.
Why does Corghi A 9222 HP TI Tyre Changers table top demount or mount tires with difficulty?
If the table top demounts or mounts tires with difficulty, it could be due to insufficient belt tension. Adjust the belt tension or change it.
What to do if Corghi Tyre Changers bead breaking cylinder leaks air at pin?
If the bead breaking cylinder leaks air at the pin, it's likely due to worn seals. Try changing the gaskets or change the bead breaker cylinder.
Why Corghi Tyre Changers table top makes a third of a turn and then stops?
If the table top makes a third of a turn and then stops, the gear motor might be seizing. In this case, change the gear motor.
How to fix Corghi Tyre Changers table top not clamping rim?
If the table top does not clamp the rim, it could be due to a defective table top cylinder or worn clamping slide grippers. Try changing the table top cylinder or changing the sliding clamp.
What to do if Corghi A 9222 HP TI table top will not turn in one direction?
If the table top will not turn in one direction, the reverser switch is broken. Change the reverser switch.
Why Corghi A 9222 HP TI bead breaker and table top rotate pedals do not return to their home positions?
If the bead breaker and table top rotate pedals do not return to their home positions, it could be due to a broken pedal return spring or an empty grease nipple. Change the pedal return spring or top up the grease nipple with SAE 20 non detergent oil.
General| Category | Tyre Changers |
|---|---|
| Manufacturer | Corghi |
| Model | A 9222 HP TI |
| Operating Pressure | 8-10 bar |
| Air Pressure | 8-10 bar |
| Maximum Rim Diameter | 22 inches |
| Minimum Rim Diameter | 10 inches |
To Next Page