Maintenance
51
adding the oil specified into the opening “A”;
• Screw the top “A” back on sealing it properly, and turn
on the motor following the correct procedure;
• Briefly operate the drive levers and the command
levers;
• Stop the motor and check that the level of the oil “C”
reaches the red line “D” and, if necessary, repeat the
operation.
Substitution
Every 300 hrs
Substitute the hydraulic oil in the
tank.
To substitute the hydraulic oil, use a suitable aspirator
and work when the oil is cool, verifying its temperature
using the thermometer.
DANGER: Always carry out
when the motor is off and with the body
blocked with the special bar.
Empty the upper tank first;
• Unscrew the top “A” on the upper tank, removing the
washer “B”, and vacuum the oil using a suitable
fig. 70 – Substitution of oil and filters
To Next Page
Loading...
