Why does my Cornelius Dispenser blow a fuse or circuit breaker?
A blown fuse or circuit breaker in your Cornelius Dispenser can be due to: * A short circuit in the electrical wiring, which requires wiring repair. * An inoperable agitator motor (shorted motor), which requires replacing the gear motor.
What to do if the Cornelius Dispenser ice dispenses continuously?
If your Cornelius Dispenser is dispensing ice continuously, it could be due to: * The ice gate mechanism being stuck in the open position. Inspect the gasket for proper position and examine the gate plate to see if it slides freely behind the lower ice chute. * A stuck or bent ice lever that prevents the gate from closing and opening the reed switch. Examine the ice dispense lever to see if it is bent.
Why does my Cornelius IDC PRO 255 Beverage Dispenser keep blowing fuses?
A blown fuse or circuit breaker in your Cornelius Beverage Dispenser may be due to a short circuit in the electrical wiring. In this case, you should repair the wiring. Another possible cause is an inoperable agitator motor, meaning the motor is shorted. If this is the case, replace the gear motor.
How to fix low water pressure in Cornelius Beverage Dispenser?
Low water pressure in your Cornelius Beverage Dispenser could be due to excessively long runs (over 40 ft.) of 3/8” water supply line, so increase the line size to 1/2”. Alternatively, it could simply be low water pressure, in which case you should add a water pressure booster pump. A plugged water filter can also cause this issue, so try changing the water filter. Finally, the water booster bladder may have burst, requiring you to replace the water booster tank/bladder.
Why is my Cornelius Beverage Dispenser dispensing ice continuously?
Continuous ice dispensing from your Cornelius Beverage Dispenser may be caused by the ice gate mechanism being stuck in the open position. Inspect the gasket for proper position and examine the gate plate to see if it slides freely behind the lower ice chute. Another cause could be a stuck or bent ice lever, which prevents the gate from closing and opening the reed switch. Examine the ice dispense lever to see if it is bent.
Why is there slushy ice or water in the hopper of my Cornelius IDC PRO 255?
Slushy ice or water in the hopper of your Cornelius Beverage Dispenser can result from blocked drains in the cold plate. Remove the access covers in the cold plate cover and inspect/clean the drains. Another possible cause is poor ice quality due to water quality or ice maker problems, so correct the water quality or repair the ice maker.
What to do if the beverage does not dispense from Cornelius Beverage Dispenser?
If the beverage does not dispense from your Cornelius Beverage Dispenser, the first thing to check is whether there is 30 VDC to the valves. If not, restore it. If there is no touch response, try restarting the unit.
Why is the beverage from my Cornelius IDC PRO 255 Beverage Dispenser too sweet?
If the beverage from your Cornelius Beverage Dispenser is too sweet, it may be that the valve BRIX requires adjustment. In this case, adjust the valve BRIX.
What to do if ice dispenses continuously from Cornelius Dispenser?
If the ice dispenses continuously from your Cornelius Dispenser, it could be due to a couple of reasons. First, the ice gate mechanism might be stuck in the open position. You should inspect the gasket to ensure it's properly positioned and check if the gate plate slides freely behind the lower ice chute. Another possibility is that the ice lever is stuck or bent, preventing the gate from closing and opening the reed switch. Examine the ice dispense lever to see if it is bent.
General| Brand | Cornelius |
|---|---|
| Model | IDC PRO 255 |
| Category | Beverage Dispenser |
| Language | English |
To Next Page
