CTG2000 / CTG3000 / CTG5000 2 09/20/19
CTG2000 / CTG3000 / CTG5000
1/4", 3/8", & 1/2" Digital Torque Wrench
METHODS TO AVOID HAZARDOUS SITUATIONS
• To safeguard torque accuracy avoid keeping tool set at high loads for long periods of time. When finished reset back to zero.
• Do not operate without eye and hand protection (users and bystander).
• Keep body working stance balanced and firm. Do not overreach when operating the tool.
• Keep fingers and hands away from pinch point region of this tool at all times.
• Do not force tool beyond its rated capacity. Overtorqueing can cause breakage.
• Use of a "cheater bar" or leverage multipliers will result in an inaccurate reading and can possibly damage the wrench. Use of
unapproved accessories could push the unit beyond its rated capacity and will void your warranty.
• Do not use torque wrench to loosen fasteners.
• The wrench should be sent in for calibration once every year or every 5,000 cycles for re-calibration.
• The wrench should be cleaned and stored properly after every use. Do not submerge this unit in any fluid.
• Wrenches should be re-calibrated if dropped or accidentally mishandled.
• The torque wrench should be "exercised" a minimum of three times at 100% of full scale before use.
• Do not remove any labels. Replace damaged labels.
• Communications port is for use by authorized service center technicians only.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and not comply with them, and neglecting the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
WA RNING
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
This Instruction Manual Contains Important Safety Information. Read THIS INSTRUCTION MANUAL Carefully and understand
ALL INFORMATION Before Operating THIS Tool.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost
or not legible, contact Cornwell Tools for replacements. If the operator is not fluent in English, the product and safety instructions shall
be read and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the
operator comprehends its contents.
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING INFORMATIONS
To Next Page
Loading...
Need help?
General
