GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed
below may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this unit until they have read
this manual and have developed a thorough understanding of how this unit works.
WARNING: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors which cannot be built into this
product but must be supplied by the operator.
WARNING: This product can expose you to chemicals including Lead, which is known to the
State of California to cause cancer and birth defects or other reproductive harm. For more
information go towww.P65warnings.ca.gov
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY CONSIDERATIONS
1.1 Your Welding/Cutting Environment
-Keep the environment you will be welding/cutting in free from flammable materials.
-Always keep a fire extinguisher accessible to your plasma cutting/welding environment.
-Always have a qualified person install and operate this equipment.
-Make sure the area is clean, dry and ventilated. Do not operate the plasma cutter in humid, wet or
poorly ventilated areas.
-Always have your plasma cutter maintained by a qualified technician in accordance with local, state
and national codes.
-Always be aware of your work environment. Be sure to keep other people, especially children, away
from you while you are cutting.
-Keep harmful arc rays shielded from the view of others.
-Mount the plasma cutter on a secure bench or cart that will keep the plasma cutter secure and prevent
it from tipping over or falling.
1.2 Your Plasma Cutter’s Condition
-Check ground cable, power cord and torch cable to be sure the insulation is not damaged. Always
replace or repair damaged components before using the plasma cutter.
-Check all components to ensure they are clean and in good operating condition before use.
To Next Page
Loading...
