Electromagnetic Field
Electromagnetic fields can interfere with various electrical and electronic
devices such as pacemakers.
-Consult your doctor before using any plasma cutting device
-Keep people with pacemakers away from your plasma cutting area while cutting.
-Do not wrap cable around your body while plasma cutting.
- Wrap plasma torch cable and ground cable together whenever possible.
- Keep plasma torch and ground cables on the same side of your body
.Shielding Gas Cylinders Can Explode
High pressure cylinders can explode if damaged, so treat them
carefully.
-Never expose cylinders to high heat, sparks, open flames, mechanical shocks or arcs
-Do not touch cylinder with plasma torch.
-Do not plasma cut on the cylinder.
-Always secure cylinder upright to a cart or stationary object
-Keep cylinders away from welding/cutting or electrical circuits.
-Use the proper regulators, gas hose and fittings for the specific application
Proper Care, Repair and Maintenance
Always have power disconnected when working on internal components.
-Do not
-Do not touch or handle PC board without being grounded with a wrist strap. Put PC board in static
proof bag to move or ship.
-Do not put hands or fingers near moving parts such as drive or fan.
Always h
Proposition 65 Warnings
Plasma cutting equipment produces fumes or gases which contain chemicals
known to the state of California to cause birth defects and, in some cases, cancer.
(California Health & Safety code section 25249.5 et seq.)
MMWP700DVI USE AND CARE
• Do not modify this unit in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the equipment. There are specific applications for which this
unit was designed.
• Always check of damaged or worn out parts before using this unit. Broken parts will affect
this unit’s operation. Replace or repair damaged or worn parts immediately.
• Store idle MMWP700DVI. When this unit is not in use, store it in a secure place out of the
reach of children. Inspect it for good working condition prior to storage and before re-use.
To Next Page
Loading...
