RECOMMENDED MAINTENANCE SCHEDULE
BEFORE EVERY USE
• Confirm that cables are tight and secure.
• Visually check lenses for dust.
AFTER EVERY USE
• Place lens caps on cameras.
• Back up any critical tests to safe media.
EVERY 1 MONTH
• Perform a full dust check per the instruction by viewing a blank white wall.
• Dust front and back of lens and sensor glass with clean compressed air.
• Check calibration grids for any heavy damage or smudges; clean with soap and water as necessary.
• Back up any important tests from hard drive to safe or offsite media.
EVERY 6 MONTHS
• Inspect all cables for crimps/damage.
• Disconnect both ends of camera cables and check for damaged connectors.
• Open PC and carefully dust motherboard and fans.
EVERY 12 MONTHS
• Consider renewing support contract – this will extend hardware warranty for as long as the contract is
continuous.
To Previous Page
Loading...