Corsair FLASH VOYAGER - Running the USB Flash Disk Utility Program

Hi-Speed USB Portable Flash Disk User’s Manual Guide
Page 8
Also check your Program folder by clicking Start-Programs and see if there is a
USB Flash Disk Utility program folder created. Please refer to the next section on
how to use the utility program.
Running the USB Flash Disk Utility Program
Note: The USB Flash Disk Utility program only runs if it detects the correct device.
The program will not respond if it detects a different factory configured device
even if it is also from the same manufacturer.
Follow the steps below to run the program:
1. In order to run the USB Flash Disk utility, it is required that you first plug-in
the device and then double-click the program shortcut in the desktop screen.
Otherwise, the program will not open if it cannot detect the proper device.
2. The USB Flash Disk Utility menu window will appear. The password features
will only be enabled if you partition the device into two partitioned disks. If
there is a password already enabled on the disk, the password check dialog
box will pop-up to prompt for the password before you can enter the main
menu.
Note: The Password Check dialog box will only pop-up if this option is enabled
when you plug-in the device and there is a password enabled. You can disable
this auto pop-up function by clicking the Option button in the main menu of
the utility program.
3. You will also see the USB Flash Disk utility icon on the right side of the taskbar
each time you plug-in the device. You can also double-click this to open the
utility. Click on the Option button to disable the tray icon appearing on the
taskbar when you plug in the device.