Corsair FLASH VOYAGER User Manual

Hi-Speed USB Portable Flash Disk User’s Manual Guide
Page 5
In Windows 2000 or ME, whenever you unplug the disk without safely removing it,
Windows will show you a warning message that unplugging a device without
stopping it may cause your computer to
crash or lose valuable data. To avoid data
loss, do not disconnect the Corsair Flash Voyager USB 2.0 Flash Drive when the
read/write LED of the disk is still on.
Note: Do not unplug or remove the device if the read/write LED of the Corsair
Flash Voyager USB 2.0 Flash Drive is on or blinking. This means that the computer
is still accessing the device. Wait for the LED to turn off before you safely remove
the device.
Generic USB Hub Driver Installation
The Corsair Flash Voyager USB 2.0 Flash Drive uses an embedded generic
USB hub that may cause Windows to prompt for a driver installation upon its first
use on a computer.
Note: If you are using Windows 98, it is required that you first install the Win98
USB mass storage driver before you connect the device. You can run the USB Flash
Disk Utility Setup program to install the needed Win98 driver or you may install
the stand-alone driver.
1. When you connect the Corsair Flash Voyager USB 2.0 Flash Drive to a Hi-
Speed USB 2.0 port for the first time, Windows will first detect the Generic
USB Hub on the USB 2.0 Bus and may prompt you to install a driver. You
may use the existing USB host driver in Windows. Click Next to continue.

Corsair FLASH VOYAGER Specifications

General

Connector Type	USB Type-A
Operating Temperature	-20°C to 60°C
Capacity	16GB, 32GB, 64GB, 128GB
Storage Temperature	-20°C to 85°C
Compatibility	Windows, Mac, Linux