13ASSEMBLY INSTRUCTIONS |
1. Attach (#49) large shock pad, (#21) left safety bar, another (#49) and (#20) welded sliding sleeve onto
(#19), repeat on the other side.
2. Install (#19) and (#20) into (#18) welded hold rod. Then Insert (#19) into (#5) and (#6) holes, then
secure the upper end with bolts (#60) and flat spacer (#63).
3. Secure (#23) barbell sleeve onto (#18) and secure with bolts (#61) and flat spacer (#65). Add the
spring collar (#48) to (#23).
4. Attach (#25) to (#5) as shown in the figure and secure with (#46) ball stud. Place (#45) internal
casing into (#26) then install (#26) to (#25) using (#27), flat spacer (#63) and nut (#64). Repeat on the
other side.
STEP 5
60
63
19
61
65
48
23
20
26
64
25
27
45
49
21
49
46
18
24
22
To Next Page
Loading...
