No vibration! Why?
1.Your game does not support vibration
2.The vibration function is not activated in the settings of your game
My controller is not working!
1.Check the switch maybe [OFF]
2.Charge your controller
HOW TO CONNECT THE CB CONTROLLER TO YOUR PC?
Required configuration:
Operating System: Windows® XP to Windows 10
One USB port
1.Plug the Nano USB receiver to your computer
Warning: You must install the Cosmic Byte driver for your controller running Windows® XP To
avoid malfunctions (loss of vibration, disconnection…)
When you plug the Nano receiver into a USB port on the back of your PC, please use a USB
Extension Cable, if you face unstable connectivity issue.
2.Turn on your controller by setting the switch to [ON] and press [START]
3.The four LED indicators flash
4.Your controller is connected to your PC while the First LED stays on
5.To operate vibration mode under Dinput mode, please install the Cosmic Byte driver
COSMIC BYTE DRIVER INSTALLATION:
DRIVER INSTALLATION IS ONLY REQUIRED FOR WINDOWS XP
Browse the CD and double click on “Setup” and follow the instructions to install the Cosmic Byte
driver.
To access the settings of your controller, click [START]>[Control Panel]>[Game
Controllers]>[Settings] (the path may vary depending on your OS; the example is based on
Windows XP)
To Next Page
Loading...