16
PROBLEM POSSIBLE CAUSE SOLUTION
Cooktop will not
operate
a.) A household fuse blown, or
a circuit breaker tripped.
b.) Cooktop not wired properly.
c.) Control knobs are not set
correctly.
Use cookware about the same
size as the surface cooking
area, element or surface
burner. Cookware SHOULD
NOT extend more than 1/2”
(1.3 cm) outside the cooking
area, see Page 9.
Excessive heat
around the
cookware on
cooktop
Cookware is not the proper
size.
a.) Refer to “Cookware”
section, Page 10.
b.) Refer to “Cooktop Controls”
section Page 7.
c.) Level the cooktop. Refer to
Installation Manual, Page 12,
"Prepare Cooktop for
Installation".
Cooktop cooking
results not what
expected
a.) Is the proper cookware
being used?
b.) Is the control knob set to
the proper heat level?
c.) Is the cooktop level?
During the first use(s), a vapor
may be seen exiting the holes
around the knobs of the
cooktop. This is normal and
SHOULD disappear after use.
A vapor is being
emitted from the
knobs of the
cooktop
Is the cooktop in its first
use(s)?
TROUBLESHOOTING
a.) Replace the fuse or reset
the circuit breaker. If the
problem continues, call an
electrician.
b.) Refer to “Installation
Instructions” in the Cooktop
Installation Manual.
c.) Push in knob before turning
to a setting.
To Next Page
Loading...
Need help?
General
