13
TO SET THE TIMER
The digital countdown timer can be set up to 11 hours and 59 minutes
maximum.
1. If the clock was previously set, press the function button repeatedly until
the indicator bar blinks above "Set Clock".
2. Press or hold the + or - button to adjust the clock. The clock will be
confirmed automatically if you leave the correct time there for 5 seconds
without pressing any buttons, and the indicator bar will become solid. You
may also press the function button to confirm the clock manually while the
indicator bar is blinking.
1. Press the function button repeatedly until the indicator bar blinks above
"Timer Set".
2. Press or hold the + or – button to set the length of time, then press the
function button or wait for 5 seconds to confirm.
Once confirmed, the current time will be shown and the countdown will begin.
When the countdown is finished, press any button to stop the beeping.
To view and modify the countdown time remaining, press the function button
once to select "Timer Set" again and use the + or - button to adjust the
current timer as needed; To cancel the timer, follow the steps above to set the
length of time to 0.00.
NOTE: When adjusting the time, idling for 5 seconds without pressing any
buttons will automatically confirm the current time on the display.
IncreaseDecrease Function
To Next Page
Loading...
Need help?
General
