Pendular Spreader PDV-PDHV models
19
3) Establish the feed motion speed to be kept during the working (from 4km/h to 15 km/h).
EXAMPLE 3: feed motion speed = 6 km/h
4) Control on the slide ruler the product quantity in kg/min (or lbs/ min) that will be spread.
EXAMPLE 4: Product quantity to be spread = 24 kg/min
5) see the Spreading Chart label affixed on the hopper and shown on next paragraph (5.1.3).
According to the type of fertiliser (or product) used and to the product quantity in kg/min
established on the point mentioned above, get from the first line of the chart the value to which the
dosing rod, located on the spreader, should be positioned.
EXAMPLE : Fertilizer used = Magnatrox
Table in Kg/min= 23,4
Dosing rod setting = 24
Dosing rod
To Next Page
Loading...
Need help?
General
