Pendular Spreader PDV-PDHV models
26
6.2. PENDULUM REPLACEMENT
In case the pendulum breaks or gets damaged, it will be necessary to replace it with an original one
supplied by the Manufacturer.
Insert the aluminium flange on the pendulum base, insert the
fixing screws (A) and the relative nuts, one by side, and screw up
them with two wrenches.
All the fixing devices (screws and nuts) must be the same the
Manufacturer prescribed.
6.3. STORAGE
It is a good use not to wait for using the machine to carry out repairing and maintenance. To repair
and to replace the parts that are broken or damaged before the storage, in order to have always the
machine ready for being used.
To store the machine in a sheltered place away from atmospheric agents and protect it in order to
avoid deteriorations.
The fertilizers are generally corrosive. For this reason it is important that no particles of
fertiliser remains on the machine for long period of time.
Before storing the machine for long periods, it is opportune to operate as follows:- wash accurately
the machine and the inside of the hopper;
- to carry out a general control by sight of the machine in order to check eventual structural
damages,
to find eventual deep abrasions on the paint;
- to check that the safety signals are presents in their positions, that they are integral and
readable, and in case they are deteriorated or unreadable, carry out immediately their substitution
(see par. 3.1);
- to grease all the mechanical parts;
- to store, if possible, the machine in a sheltered place.
6.4. SPARE PARTS
For the replacement of parts of the pendular spreader, the customer must use just original parts,
ordering them directly to the manufacturer of the machine to authorized dealers.
Carrying out the order, it is necessary to specify what the identification label brings, in particular:
- serial number
- model
- manufacturing year
- frame number
To Next Page
Loading...
Need help?
General
