Cotech 36-7334 - Rain Gauge Setup; Thermometer;Hygrometer Setup

9
ENGLISH
Rain gauge
1. Remove thewater collector by turning it in thedirection of thearrow and then
lifting it upwards.
2. Remove thebattery cover. 3. Insert 4×AAA/LR03 batteries.
Theunit will begin to transmit data once
every 60 seconds.
4. Replace thebattery cover.
Thermometer/hygrometer
Note:
• If you are to connect any additional thermometers (other than that which is supplied),
these must be set so that they transmit on different channels. This is done by
altering theDIP switches in thebattery compartment. Atotal of 8 thermometers
may be connected.
• Ensure that theDIP switches have been set before you insert batteries into thesensor.