What to do if my CountyLine CLA202 Water Pump has low voltage?
Consider installing a larger wire from the meter to the pressure switch and from the pressure switch to the pump. If necessary, have the power company raise the supply voltage.
What to do if my CountyLine CLA202 Water Pump has low or high voltage?
If the voltage variation is more than ±10%, contact your power company to adjust the voltage.
What to do if my CountyLine Water Pump is stuck or binding?
If necessary, pull the pump and perform all possible above-ground checks first. If the pump is locked, replace it. Prior to reinstalling the pump, make sure to clean the well of all sand or lime.
What to do if my CountyLine CLA202 Water Pump has a tank waterlogged?
If you have air-over-water tanks, repair or replace the tanks. If necessary, replace the air pressure valve.
What to do if my CountyLine CLA202 pressure switch is defective?
Readjust or replace the pressure switch.
What to do if my CountyLine CLA202 has a plugged intake screen?
Clean or replace the intake screen as necessary.
What to do if my CountyLine CLA202 Water Pump has wrong size fuse?
Install the correct fuse or time delay fuse.
What to do if my CountyLine CLA202 Water Pump has a wire size too small?
Install the correct size wire.
What to do if my CountyLine Water Pump has a leak in drop pipe?
Replace the pipe above the point where the leak occurs.
What to do if my CountyLine CLA202 has low water level?
Lower the pump further into the well, ensuring it remains at least 5’ (1.6m) above the bottom of the well. Adjust the pump discharge until it matches the recovery rate of the well. Note: Running the pump while airlocked can cause loss of prime and seriously damage the pump.
Contains essential safety instructions for installation, operation, and maintenance. Alerts user to potential hazards.
Guidance on inspecting the pump for damage and understanding warranty void conditions.
Instructions for safely grounding the pump and motor to reduce electric shock hazards.
Details on meeting electrical codes and using appropriate copper wire for connections.
Provides diagrams for correct hook-up information for 2-wire motors, adhering to electrical codes.
Outlines methods for splicing electrical cable to motor leads using taped or heat-shrink splices.
Guidelines for connecting the power supply cable, ensuring correct voltage and frequency.
Instructions for installing the pump, including pressure tank hookup and safety rope.
Procedure for starting the pump for the first time, especially for developing a well.
Guidance on connecting the pump to the water system, including pressure relief valves and freezing prevention.
Addresses problems like the motor not starting, fuse blows, or overload protector trips.
Covers issues such as the pump starting too frequently, leaks, or tank waterlogging.
Details problems like little or no water delivered and air or milky water discharge.
Outlines the 12-month warranty period, repair/replacement options, and required documentation.
Details conditions not covered by warranty and limitations of remedies.
General| Brand | CountyLine |
|---|---|
| Model | CLA202 |
| Category | Water Pump |
| Language | English |
To Next Page