5
s !VOID USING EXTENSION CORDS
s )F YOUR PUMP OR CORD BECOMES DAMAGED REPLACE THE PUMP IMMEDIATELY
s 0LUG THE PUMP INTO A '&#) 0ROTECTED OUTLET ONLY 0LACE THE PUMP ON THE COVER lRST THEN PLUG IN THE PUMP
DO NOT stand on a wet surface while using the pump.
s !VOID CONTACTING ACCUMULATED SURFACE WATER ON YOUR COVER WHEN THE PUMP IS ON THE COVER
%LECTRIC SHOCK IS POSSIBLE 9OUR PUMP SHOULD NOT BE USED FOR ANY APPLICATION OTHER THAN SPECIlED IN THESE INSTRUCTIONS
s 9OUR PUMP HAS BEEN PROVIDED WITH A STABILIZER PLATE SO IT REMAINS UPRIGHT $/ ./4 ALLOW THE PUMP TO TIP OVER
7!2.).' 9OUr pump is an electric appliance and caution should be used when handling your pump and electric cord around water.
ALUMINUM LID
The aluminum lid on below-deck systems is a long-lasting cosmetic cover for the housing. It is not intended for anyone to walk or step on. It can be
slippery when wet and walking on it can loosen the support brackets under it. Instruct children not to step on the lid.
+%9 37)4#( ,/#!4)/.
All controls for the cover system must be located where the pool is completely visible during cover operation. All plants and shrubs should be
maintained for continuous visibility.
0!24)!,,9 #/6%2%$ 0//,3
It is extremely important to always cover or uncover the pool completely. Never leave the pool partially covered. A partially covered pool presents a
serious danger as people or pets may drown under the cover.
7!2.).' A partially covered pool can pose a safety hazard. Never leave the cover over the pool in a partially covered
position. Always completely cover or uncover the pool. Even children or pets who can swim may drown if they lose their
orientation under the cover. Never allow anyone to swim under the cover.
use and maintenance.
s !Fter the pump has removed all water from one location on the cover, it may be necessary to move the pump to other locations to remove all accumulated water.
s 4HE PUMP IS COVERED UNDER THE PUMP
manufacturer’s warranty.
s &OR SERVICE RETURN IT TO THE MANUFACTURERS SERVICE CENTER