What You Will Need to Setup the Camera:
- 8 AA Batteries
- 1 16GB SD card (Up to 32GB)
Installing the Batteries
The MP30 functions on 8 AA batteries. To install, open
the front case of the unit and slide each battery into its
appropriate slot. Make sure to pay attention to the
positive and negative terminal directions which are
molded into the front of the battery sleeve.
Installing the SD Card
Prior to powering up the camera, install a Covert SD
card into the slot on the bottom of the front case of
the unit. Push the card in until it clicks, then release.
To remove, repeat that process, the card will pop out
enough to remove. You can use any size SD card up to
32GB. Please see page 6 for instructions for formatting
your SD card.
To Next Page
Loading...
