BEFORE USE
Please check before use
The product is for 220 V – 240 V~ 50 Hz / 60 Hz only.
Make sure to connect the power plug to a grounded electric
outlet (220 V – 240 V~ 50 Hz / 60 Hz) dedicated to the
product.
How to install filter
Tip
s
-
Be sure to install the filter after removing the plastic packaging.
-
Only use it indoors.
-
When not in use, remove the power plug from the socket.
-
During filter assembly, check the front of the filters.
▶ Filter assembly order : HEPA filter → Deodorizing filter → Pre-filter
1.
Open the front cover.
Pull the upper part of the front cover to open.
2. Take out the filter and
remove
the plastic
packaging.
Remove the plastic packaging from filters,
▶
excluding the pre-filter, and assemble them
in the purifier in order.
∗
Filter assembly order : HEPA filter
→
Deodorizing
filter → Pre-filter
3.
Reattach the front cover.
Fit the two tabs on the bottom part of
the front cover into their slots and push to
install.
∗ If the front cover is not properly attached,
the product will not operate.
9
10
To Next Page
Loading...
Need help?
General
