ADJUST PARTICLE SENSOR
How to adjust the sensitivity of the pollution sensor
When you first turn on the purifier, the air quality sensor is set to standard. You can adjust
the sensitivity as follows if the air quality LED stays at severe even after the purifier runs
for 2 hours or more with high pollution or the air quality LED stays at clean even if the
pollution is high.
1.
Press and hold the air speed button and
mode
button simultaneously for about 1
second while
the purifier is running.
1 sec.
2. The air speed mode indicator flashes at
intervals of
about 0.5 seconds.
3.
Press the air speed button to adjust to your
desired
sensor sensitivity. When sensor
sensitivity is selected,
the air speed mode
indicator flashes as follows.
4.
Press the air speed and mode
buttons
simultaneously for at least 3
seconds again
to enter your selected sensitivity to operate
the
purifier normally.
ā If the air speed button and mode button are not pressed
for
10 seconds after selecting sensitivity, the selected
sensitivity is
automatically input.
3 sec.
13
14