5. Connect the shower hose B to the water extraction port (OUT) of the product. Connect the other
end of the hose (cone-shaped) to the shower head. (If water leaks after connecting the shower
head, add rubber washers assemble it again.)
6. Separate the top cover from the product and use the cap opener to open the lter tank cap as
shown in the pictures below.
7. Insert a new composite lter into the lter tank and close the lter tank cap as shown in the
pictures below.
*
Water may leak if the lter
tank cap is not fastened
securely.
8. Turn the switching valve to the ‘Soft water’ position and open the water faucet to drain the yellow
softened water for approximately 1 minutes.
FILTER
INSTALLING THE PRODUCT
How to Use
10
9
- The composite lter consists of a felt lter and
vitamin C. The felt lter removes suspended
solids and rust and the vitamin C removes any
residual chlorine.
- Although yellow water may be extracted by the
oxidized vitamin C at the beginning of each use
due to the characteristics of vitamin C, the water
is not harmful to the human body. In this case,
just drain the water for approximately 1 minute
before using softened water.
Tips