Wheel alignment system SetupWizzard 35
7.3.3 PC software configuration
After the measuring platforms have been paired with the computer, they still have to be
assigned to a vehicle corner or a system. This is done in the configuration menu of the
SetupWizzard software.
To do this, open the SetupWizzard software and select the menu item „Config” →
„Systems”. Now assign the respective vehicle corners to the measuring platforms. The
designation of the platform can be found on the underside sticker. Please note that only
the platforms previously paired with the computer can be assigned.
Optionally, it is possible to connect the platforms with the SetupWizzard software via CAN
communication. The CAN charger from the SetupWizzard accessories is needed for this.
To Next Page
Loading...