24/7 Technical Support- Toll Free 1-877-472-8200
13
Concrete Polishing Solutions- G-290 Operator’s Manual
HOW TO OPERATE THE MACHINE
The G-290 is intended for use by a professional. As such, this section is intended
to guide the operator through the operation of the G-290. It is not intended as
instruction on grinding or polishing of oors. The term “plates” is used to mean any
of the attachments (metal bond plates, resin plates, etc.) applicable to the process.
1. Adjust the handlebars to desired height and grasp rmly.
2. Stand behind G-290 with feet planted rmly and evenly on
ground
3. Press the “RUN” button to engage power supply.
The following steps should be done after completeing the instructions in “Preparing
the Machine:”
IMPORTANT! Never hold the machine in one place while it is
still on. The G-290 must remain in constant motion. Holding the
machine still may cause “swirling” and damage to oor.
To Next Page
Loading...