CPS g-290 - Best Practices for Grinding; Recommended Grinding Procedures

To Next Page

To Previous Page

24/7 Technical Support- Toll Free 1-877-472-8200

Concrete Polishing Solutions- G-290 Operator’s Manual

BEST PRACTICES

12. Unplug electrical cord from outlet rst, then unplug from G-290 and

store as appropriate.

When grinding with the G-290, one should do a forward pass followed by

a back pass. No weights are to be used in the following steps:

1. Using 40 grit metal bond diamonds:

Run G-290 between a 6 and 7 speed setting

Foot Speed - Slow and easy, natural walking pace

2. Using 150 grit metal bond diamonds:

Run G-290 between a 6 and 7 speed setting

Foot Speed - Slow and easy, natural walking pace

3. Using 100 grit resin bond diamonds:

Run G-290 between a 4.5 and 6 speed setting

Foot Speed - Slow and easy, natural walking pace

Each oor is dierent and requires the operator to have a certain amount

of expertise in determining which tools are most appropriate for each

job. CPS is happy to discuss any questions regarding the G-290 and the

grinding polishing process. Please feel free to contact our Customer

Service Department.