Craftex CX212 User Manual

11
Place the fence on the fence rails and press
the handle down to lock the fence in
position. See figure-11.
Figure-11 Installing the fence
Loosen the lock lever shown in figure-12.
Insert the spreader into the mounting block
and tighten the lock lever. See figure 12.
Figure-12 Using the knob to secure the
spreader
Make sure the spreader is locked properly.
Install the blade guard on the spreader and
lock it in position by tightening the lock
lever.
Figure-13 Installing the blade guard
Install the dust port to the table saw cabinet
and secure it using screws provided. See
figure-14.
Figure-14 Installing the dust port

Craftex CX212 Specifications

General

Brand	Craftex
Model	CX212
Category	Saw
Language	English