12
CONNECTING TO A DUST
COLLECTOR
CX212 features a 4” diameter dust port to
connect to a dust collector.
When connecting to a dust collector, use a
proper sized hose and make sure all the
connections are sealed tightly.
It is recommended to use a proper sized
dust collector with the CX212 to ensure
adequate dust collection.
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
To test run the machine:
Make sure you have read the safety
instructions given in the manual and your
machine is set up properly.
Lower the blade all the way down and make
sure all tools used for setup are removed
from the machine.
Connect the machine to the correct power
source.
Turn the machine ON and verify that the
machine runs smoothly without any
problems or noises.
WARNING!
The fine dust particles produced by the
table saw can go into your lungs and
cause serious respiratory problems.
Make sure to wear a dust mask and
connect the table saw to a proper dust
collection system while operating it.
WARNING!
Before starting the table saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
To Next Page
Loading...
Need help?
General
