Craftmade Pro Plus 52 - Testing Your Fan

9. Testing Your Fan.
It is recommended that you test fan before
nalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain. Start at the OFF
position (no blade movement). First pull will set
the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF
setting. (diagram 1) If fan does not function,
please refer to "Troubleshooting" section to
solve any issues before contacting Customer
Service.
Turn fan completely o before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
dierence in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the
middle position (diagram 4), fan will not
operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to end of
the pull chain.
pull chain
extension
diagram 2 diagram 3 diagram 4
diagram 1
page 9
motor
housing
reverse switch