To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 137.248880 and is the answer not in the manual?
General| Model Number | 137.248880 |
|---|---|
| Type | Circular Saw |
| Motor | 15 Amp |
| Cord Length | 6 feet |
| Bevel Capacity | 56 degrees |
| No Load Speed | 5000 RPM |
| Depth of Cut at 90 degrees | 2-7/16 inches |
| Depth of Cut at 45 degrees | 1-3/4 inches |
| Blade Diameter | 7-1/4 inch |
Details of the manufacturer's warranty for the table saw.
Lists key technical details of the table saw, including motor and blade specs.
Essential safety rules for operating any power tool.
Critical safety rules for table saw operation to prevent injury.
Instructions for safe electrical connection and extension cord usage.
Importance and procedure for proper grounding of the saw.
List of recommended accessories and necessary tools for assembly.
Steps for unpacking and verifying all parts are present.
Diagram and labels identifying all parts of the table saw.
Step-by-step guide for assembling the table saw stand.
Instructions for mounting the table saw unit onto its assembled stand.
Securing the saw to a surface and installing the dust bag.
Operating the blade raising and tilting handwheels.
Procedures for installing the rip fence and changing the saw blade.
Steps for assembling the blade guard and installing table side extensions.
Installing rear table extensions and aligning the rip fence.
Adjusting the rip fence indicator and positive stops for blade angles.
Ensuring the blade is parallel to the miter gauge groove for accuracy.
Making additional adjustments for optimal blade alignment.
Operating the blade elevation, tilt, ON/OFF switch, and overload protection.
Proper use and adjustment of table extensions.
Step-by-step guide for performing ripping cuts safely.
Techniques for bevel ripping and safely cutting small pieces.
How to perform crosscuts and use wood facing on the miter gauge.
Techniques for mitering and using wood facing on the rip fence.
Instructions for safely performing dado cuts with the saw.
Routine maintenance for the saw, including cleaning and cord checks.
Checking blade mechanisms for looseness and proper lubrication points.
Identifies common problems and provides corrective actions for the table saw.
Lists and identifies parts shown in Schematic A.
Lists and identifies parts shown in Schematic B.
Lists and identifies all parts specific to the table saw stand.
Lists and identifies all parts belonging to the saw's motor.
A pattern for creating a custom push stick for safe sawing operations.
