To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 152.229020 and is the answer not in the manual?
General| Model Number | 152.229020 |
|---|---|
| Type | Angle Grinder |
| Voltage | 120V |
| No Load Speed | 10, 000 RPM |
| Spindle Thread | 5/8"-11 |
| Amperage | 6A |
| Wheel Diameter | 4-1/2 inches |
| Arbor Size | 7/8 inches |
General safety guidelines and precautions for operating the drill press.
Instructions and warnings to review before operating the drill press.
Recommendations for selecting and using extension cords with the drill press.
Essential information on properly grounding the drill press for electrical safety.
Detailed safety rules and precautions specific to operating the drill press.
Lists recommended accessories and where to obtain them for the drill press.
Steps for unpacking the drill press and verifying all parts are present.
Lists the tools needed for assembly and alignment of the drill press.
Detailed steps for assembling the main structural components of the drill press.
How to operate the power switch and safety lock for the drill press.
Instructions for using and safety considerations for the drill press's flexible work lamp.
Guide to selecting correct drill speeds and adjusting belt tension.
Guidance on selecting speeds, drilling different materials, and general operation techniques.
Instructions for changing the drill press motor from 120V to 240V.
Information on lubricating the drill press quill and spindle assemblies.
Procedures for cleaning the drill press, including safety warnings.
