EasyManua.ls Logo

Craftsman 247.288831 - User Manual

Craftsman 247.288831
92 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A.
Visit our website: www.craftsman.com
Operator’s Manual
LAWN TRACTOR
7 Speed, Shift-on-the-Go
42” Deck
Model No. 247.288831
®
For answers to your questions about
this product, Call:
1-800-659-5917
Craftsman Tractor Help Line
7 am - 7 pm CT, Mon. - Sun.
This product has a low emission engine which operates differently
from previously built engines. Before you start the engine, read and
understand this Operator’s Manual.
• Espanol, P. 58
CAUTION
Before using this equipment,
read this manual and follow
all safety rules and operating
instructions.
Form No. 769-06501B
(February 3, 2012)

Table of Contents

Questions and Answers

  • L
    Lisa SmallAug 16, 2025
    What to do if Craftsman 247.288831 engine runs erratically?
    • K
      khudsonAug 17, 2025
      If your Craftsman Lawn Mower engine is running erratically, consider these potential causes: * The unit might be running with the CHOKE activated. Deactivate the CHOKE. * Spark plug wires might be loose. Connect the spark plug wires. * The fuel line might be blocked, or the fuel could be stale. Replace the fuel line, fill the tank with clean, fresh gasoline, and replace the fuel filter. * The vent in the gas cap could be plugged. Clear the vent or replace the cap if it's damaged. * There might be water or dirt in the fuel system. Drain the fuel tank and refill it with clean, fresh gasoline. * The air cleaner might be dirty. Replace the air cleaner paper element or clean the foam pre-cleaner, if equipped.
  • C
    Courtney HicksAug 21, 2025
    Why does my Craftsman 247.288831 Lawn Mower engine idles rough?
    • A
      Alex JordanAug 21, 2025
      A rough idle in your Craftsman Lawn Mower engine could be due to: a spark plug that is fouled, faulty, or has a gap that is too wide. Replace the spark plug and set the plug gap. Another potential cause is a dirty air cleaner. Replace the air cleaner element and/or clean the pre-cleaner.
  • A
    Ann JarvisAug 25, 2025
    What causes an uneven cut with a Craftsman 247.288831 Lawn Mower?
    • C
      Crystal JacksonAug 25, 2025
      An uneven cut with your Craftsman Lawn Mower can result from: the deck not being leveled properly. Perform a side-to-side deck adjustment. A dull blade can also cause an uneven cut. Sharpen or replace the blade. Uneven tire pressure can also be the culprit. Check the tire pressure in all four tires.
  • E
    emily16Aug 28, 2025
    Why is my Craftsman Lawn Mower engine overheating?
    • S
      Sarah MooreAug 28, 2025
      Your Craftsman Lawn Mower engine might be overheating due to: a low engine oil level. Fill the crankcase with the proper amount and weight of oil. Another cause may be restricted airflow. Clean grass clippings and debris from around the engine’s cooling fins and housing.
  • K
    kevinkennedySep 1, 2025
    What to do if my Craftsman 247.288831 won't mulch grass?
    • B
      Brandon NelsonSep 1, 2025
      If your Craftsman Lawn Mower isn't mulching grass effectively, check the following: * Ensure the engine speed isn't too low. Place the throttle in the FAST (rabbit) position. * Avoid mulching when the grass is wet. * If the grass is excessively high, mow once at a high cutting height, then mow again at the desired height, or make a narrower cutting swath. * A dull blade can also prevent mulching. Sharpen or replace the blade.
  • T
    Tiffany MillerSep 4, 2025
    How to fix excessive vibration in Craftsman Lawn Mower?
    • C
      christopher20Sep 4, 2025
      Excessive vibration in your Craftsman Lawn Mower can be caused by: a loose or unbalanced cutting blade. Tighten the blade and spindle. Alternatively, the cutting blade might be damaged or bent. Replace the blade.
  • S
    Shirley TrujilloSep 8, 2025
    What causes Craftsman 247.288831 Lawn Mower engine to hesitate at high RPM?
    • J
      jonesrichardSep 8, 2025
      If your Craftsman Lawn Mower engine hesitates at high RPM, it might be because the spark plug gap is too close. Remove the spark plug and reset the gap.
  • P
    Paul PorterNov 12, 2025
    Why won't my Craftsman 247.288831 Lawn Mower engine start?
    • G
      gfoxNov 12, 2025
      There are several reasons why your Craftsman Lawn Mower engine might fail to start: * The PTO/Blade Engage lever might be engaged. If so, place the lever in the disengaged (OFF) position. * The parking brake may not be engaged. Engage the parking brake. * Spark plug wires might be disconnected. Connect the wire(s) to the spark plug(s). * The throttle/choke control lever might not be in the correct starting position. Place the Throttle/Choke lever into the FAST position. * The choke might not be activated. Move the Throttle/Choke lever into the Choke position. * The fuel tank could be empty or contain stale fuel. Fill the tank with clean, fresh (less than 30 days old) gas. * The fuel line may be blocked. Replace the fuel line and the fuel filter. * The spark plug(s) might b...

Summary

WARRANTY STATEMENT

CRAFTSMAN FULL WARRANTY

Describes warranty coverage for parts, frame, and axle.

WARRANTY SERVICE

Details how to obtain warranty service.

SAFETY INSTRUCTIONS

GENERAL OPERATION

Instructions for general operation and safety.

SLOPE OPERATION

Guidelines and warnings for operating on slopes.

CHILDREN SAFETY

Precautions regarding children's safety around the machine.

TOWING GUIDELINES

Instructions and warnings for towing equipment.

SERVICE SAFETY

Safe handling of gasoline and other service-related safety.

GENERAL SERVICE SAFETY

Maintenance safety, emissions, and spark arrestor information.

SAFETY SYMBOLS

Explains safety symbols used in the manual.

ASSEMBLY

ATTACHING BATTERY CABLES

Connects the battery cables to the tractor.

SHIPPING BRACE REMOVAL

Instructions for removing the shipping brace.

ATTACHING STEERING WHEEL

Guides on how to attach the steering wheel.

ATTACHING THE SEAT

Instructions for mounting the tractor seat.

TIRE PRESSURE

Recommended tire pressure for optimal operation.

OPERATION

TRACTOR CONTROLS OVERVIEW

Identifies and explains the tractor's controls and levers.

ENGINE AND DRIVETRAIN OPERATION

Details starting, stopping, driving, PTO engagement, speed control, and parking brake.

MOWING AND MAINTENANCE OPERATIONS

Covers cutting height, fuel/oil, safety interlocks, and mowing techniques.

SERVICE AND MAINTENANCE

REGULAR MAINTENANCE SCHEDULE

Details scheduled maintenance tasks and intervals.

ENGINE MAINTENANCE PROCEDURES

Covers oil, fuel filter, air cleaner, spark plug, muffler, and cleaning.

DRIVETRAIN AND CHASSIS MAINTENANCE

Covers lubrication, battery, deck, seat, brakes, and belts.

TIRE AND BATTERY CARE

Information on tire pressure, battery maintenance, jump-starting, and charging.

OFF-SEASON STORAGE

PREPARING THE ENGINE FOR STORAGE

Steps to prepare the engine for long-term storage.

DRAINING THE FUEL SYSTEM

How to drain the fuel tank and lines.

PREPARING THE TRACTOR

Cleaning and lubrication before storage.

TROUBLESHOOTING

ENGINE STARTING PROBLEMS

Common causes and remedies for engine failure to start.

ENGINE OPERATION ISSUES

Troubleshooting erratic engine running and overheating.

MOWING AND CUTTING PROBLEMS

Solutions for rough idling, vibration, and uneven cuts.

PARTS LIST

TRACTOR FRAME AND BODY PARTS

Components related to the tractor's chassis, frame, body, and fenders.

STEERING, DRIVE, AND DECK COMPONENTS

Parts for steering, transmission, drive belts, and mower deck.

ENGINE ASSEMBLY AND ACCESSORIES

Parts for the engine, including internal components, external parts, and accessories.

EMISSION CONTROL WARRANTY

WARRANTY TERMS AND CONDITIONS

Covers rights, obligations, responsibilities, provisions, and warranted parts.

WARRANTY EXCLUSIONS AND COVERAGE

Details specific exclusions and the scope of warranty coverage.

REPAIR PROTECTION AGREEMENT

AGREEMENT BENEFITS

Outlines the advantages of the repair protection plan.

SCHEDULING SERVICE

Information on how to schedule service appointments.

Craftsman 247.288831 Specifications

General IconGeneral
Cutting Width21 inches
Drive TypeSelf-Propelled
Starting SystemRecoil
Cutting Height Positions6
Cutting Options3-in-1 (Side Discharge, Mulch, Rear Bag)
Mulching CapabilityYes
Side DischargeYes
Warranty2-year limited
EngineBriggs & Stratton
Cutting Height1.25-3.75 inches
Wheel Size11 inches rear
Engine TypeGasoline

Related product manuals