How to start a Craftsman Snow Blower that won't start?
If your Craftsman Snow Blower engine won't start, make sure the choke control is in the ON position. Also, check that the spark plug wire is connected, the spark plug isn't faulty, and the fuel tank has clean, fresh gasoline. Ensure the engine is primed as instructed, and the safety key is fully inserted into the switch.
Why is my Craftsman 247.88355 losing power?
If your Craftsman Snow Blower is losing power, first, ensure the spark plug wire is securely connected and tightened. Then, check the gas cap vent hole for any blockage from ice or snow, and clear it to ensure proper ventilation.
What to do if Craftsman 247.88355 Snow Blower engine runs erratically?
If your Craftsman Snow Blower engine is running erratically, try moving the choke control to the OFF position. You may also need to fill the tank with clean, fresh gasoline or drain the fuel tank to remove any water or dirt. If the issue persists, the carburetor might need adjustment, and you should contact your Sears Parts & Repair Center.
What to do if my Craftsman 247.88355 fails to discharge snow?
If your Craftsman Snow Blower is not discharging snow, immediately stop the engine and disconnect the spark plug wire. Use a clean-out tool or stick to clear any clogs from the chute assembly and inside the auger housing. Also, check for and remove any foreign objects lodged in the auger. If these steps don't resolve the issue, the auger cable may need adjustment, the auger belt may be loose or damaged or the shear pins may be sheared.
Why does my Craftsman Snow Blower not move on its own?
If your Craftsman Snow Blower fails to propel itself, the drive cable may need adjustment, or the drive belt may be loose or damaged. Refer to the Service and Maintenance section for instructions.
Why is my Craftsman 247.88355 vibrating so much?
If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced by a Sears Parts & Repair Center.
Safe practices for operating the snow thrower, including controls and movement.
Instructions for maintaining safety devices and proper storage.
Engaging augers, drive system, and adjusting chute direction.
Checking and changing engine oil.
Table outlining maintenance intervals and tasks.
General| Engine | 208cc |
|---|---|
| Clearing Width | 24 in |
| Intake Height | 21 in |
| Start Type | Electric Start |
| Drive System | Auger-Propelled |
| Speed Settings | 6 Forward / 2 Reverse |
| Weight | 130 lbs |
| Product Type | Two-Stage Snow Blower |
| Engine Displacement (cc) | 208 cc |
| Forward Speeds | 6 |
| Reverse Speeds | 2 |
| Starter Type | Electric |
| Chute Control | Remote |
| Tire Size (in) | 13 x 4 in |
| Engine Type | 4-Cycle OHV |
To Next Page