Why is my Craftsman 247.883960 engine running erratically?
Your Craftsman Snow Blower engine might run erratically due to several reasons: * The engine might be running on CHOKE. Move the choke control to the RUN position. * You might be using stale fuel. Fill the tank with clean, fresh gasoline. * There could be water or dirt in the fuel system. Drain the fuel tank by running the engine until it stops. Refill with fresh fuel.
What to do if my Craftsman Snow Blower unit fails to discharge snow?
If your Craftsman Snow Blower isn't discharging snow, consider these potential causes: * The chute assembly might be clogged. Stop the engine immediately, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing with a clean-out tool or a stick. * A foreign object could be lodged in the auger. Stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger with a clean-out tool or a stick. * The auger cable may need adjustment. Adjust the auger control cable. Refer to Assembly section. * The auger belt could be loose or damaged. Replace the auger belt. Refer to Service and Maintenance section. * Shear pins might be sheared. Replace them with new shear pins.
What to do if my Craftsman 247.883960 has loss of power?
If your Craftsman Snow Blower is experiencing a loss of power: * Check if the spark plug wire is loose. Connect and tighten the spark plug wire. * Inspect the gas cap vent hole for blockage. Remove any ice and snow from the gas cap, ensuring the vent hole is clear.
What to do if my Craftsman Snow Blower unit fails to propel itself?
If your Craftsman Snow Blower isn't moving on its own, it might be because: * The drive cable needs adjustment. Adjust the drive control cable. Refer to Service and Maintenance section. * The drive belt is loose or damaged. Replace the drive belt. Refer to Service and Maintenance section. * The friction wheel is worn.
Why is my Craftsman Snow Blower vibrating excessively?
If your Craftsman Snow Blower is vibrating excessively, it could be due to loose parts or a damaged auger. Stop the engine immediately, disconnect the spark plug wire, and tighten all bolts and nuts.
Why chute fails to easily rotate 180 degrees on my Craftsman 247.883960?
If the chute on your Craftsman Snow Blower doesn't rotate easily, it might be assembled incorrectly. Disassemble the chute control and reassemble as directed in the Assembly section.
Why won't my Craftsman 247.883960 engine start?
There are several reasons why your Craftsman Snow Blower's engine might fail to start: * The choke control may not be in the CHOKE position. Move the choke control to the CHOKE position. * The spark plug wire might be disconnected. Connect the wire to the spark plug. * The spark plug could be faulty. Clean, adjust the gap, or replace the spark plug. * The fuel tank may be empty or contain stale fuel. Fill the tank with clean, fresh gasoline. * The engine may not be primed. Prime the engine as instructed in the Operation Section. * The key might not be inserted. Insert the key fully into the switch. * The extension cord might not be connected (if your model has an electric start button). Connect one end of the extension cord to the electric starter outlet and the other end to...
General| Engine | 208cc |
|---|---|
| Engine Type | 4-cycle OHV |
| Intake Height | 21 inches |
| Stages | Two-stage |
| Drive System | Self-propelled |
| Speed | 6 forward, 2 reverse |
| Start Type | Electric start |
| Chute Control | Remote |
| Auger Material | Steel |
| Clearing Width | 24 inches |
To Next Page