Craftsman 247.881731 - User Manual

Questions and Answers

M
Mr. Scott ReedJul 26, 2025
How to troubleshoot starting issues in a Craftsman 247.881731?
- A
  amyvillanuevaJul 26, 2025
  If your Craftsman Snow Blower engine won't start, here's what to check: * Ensure the choke control is in the CHOKE position; if not, move it accordingly. * Verify the spark plug wire is connected; if disconnected, connect it. * Inspect the spark plug for faults; clean, adjust the gap, or replace if necessary. * Make sure the fuel tank isn't empty and contains fresh gasoline; refill if needed. * Prime the engine as instructed in the Operation Section. * Ensure the key is fully inserted into the switch. * If using the electric start, confirm the extension cord is properly connected to both the snow blower and a grounded AC outlet.
I
Isabella WheelerJul 30, 2025
Why is my Craftsman 247.881731 Snow Blower engine running rough?
- M
  Mike MillerJul 31, 2025
  If your Craftsman Snow Blower engine is running erratically, consider the following: * Ensure the engine isn't running on CHOKE; move the choke control to the RUN position. * Check for stale fuel and refill the tank with clean, fresh gasoline. * Inspect for water or dirt in the fuel system; drain the tank and refill with fresh fuel.
J
Justin ReynoldsAug 3, 2025
What to do if my Craftsman Snow Blower won't throw snow?
- T
  Thomas TranAug 3, 2025
  If your Craftsman Snow Blower isn't discharging snow, here's what to do: * Immediately stop the engine and disconnect the spark plug wire. * Check the chute assembly for clogs and clean it with a clean-out tool or stick. * Look for any foreign objects lodged in the auger and remove them with a clean-out tool or stick. * Adjust the auger control cable. * If the auger belt is loose or damaged, replace it. * Replace any sheared shear pins with new ones.
K
katietaylorAug 7, 2025
What causes power loss in a Craftsman Snow Blower?
- R
  rachel06Aug 7, 2025
  If your Craftsman Snow Blower is losing power: * Check the spark plug wire and ensure it is connected and tightened. * Inspect the gas cap vent hole for blockage from ice or snow and clear it.
J
John MurphyAug 12, 2025
Why won't my Craftsman 247.881731 move forward?
- M
  michael10Aug 12, 2025
  If your Craftsman Snow Blower isn't moving: * The drive cable may need adjustment. * The drive belt might be loose or damaged. * The friction wheel could be worn.
M
Melanie CollinsAug 16, 2025
How to stop excessive vibration in my Craftsman 247.881731?
- J
  John MitchellAug 16, 2025
  If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced.
C
Christine HallAug 20, 2025
What to do if the chute on my Craftsman 247.881731 Snow Blower is hard to turn?
- R
  randyhendersonAug 20, 2025
  If the chute on your Craftsman Snow Blower won't rotate easily, the chute may be assembled incorrectly. Disassemble the chute control and reassemble as directed in the Assembly section.

Summary

SAFETY INSTRUCTIONS

Training and Preparation

Instructions for learning to operate the machine safely, including supervision and familiarization with controls.

Safe Gasoline Handling

Guidelines for safely handling gasoline to prevent fire and explosion hazards.

Operational Safety Precautions

Safety guidelines for operating, clearing clogs, and storing the machine.

Engine and Spark Arrestor Safety

Warning against engine modification and requirements for spark arrestors.

Safety Symbols Guide

OPERATION

Auger Control Operation

Throttle, Primer, and Starting Controls

Auger and Drive Controls

Clean-Out Tool and Pre-Checks

Engine Starting Procedures

Safety precautions and steps for starting the engine using electric or recoil methods.

Engaging Drive, Auger, and Stopping

SERVICE AND MAINTENANCE

Maintenance Schedule and Oil Service

Schedule for maintenance tasks and procedures for checking and changing engine oil.

Spark Plug Service

TROUBLESHOOTING

Engine Starting and Performance Issues

Common causes and remedies for engine starting, erratic RPM, and loss of power.

Mechanical and Propulsion Issues

Troubleshooting for excessive vibration and unit propulsion failures.

Snow Discharge and Chute Issues

Craftsman 247.881731 Specifications

General

Engine Type	4-cycle OHV
Engine Displacement	208cc
Intake Height	21 inches
Speed Settings	6 forward, 2 reverse
Chute Control	Manual
Wheel Size	15 inches
Product Type	Two-stage snow blower
Clearing Width	24 inches
Start Type	Electric/Recoil
Throw Distance	Up to 30 feet