Craftsman 247.881980 - User Manual

Questions and Answers

S
Samantha SmithAug 1, 2025
Why won't my Craftsman 247.881980 engine start?
- A
  anthonyjosephAug 1, 2025
  If your Craftsman Snow Blower engine won't start, try these steps: 1. Ensure the choke control is in the 'Choke' position. 2. Check that the spark plug wire is connected to the spark plug. 3. Inspect the spark plug; clean, adjust the gap, or replace it if needed. 4. Make sure the fuel tank has clean, fresh gasoline. 5. Prime the engine as shown in the Operation Section of the manual. 6. Confirm the safety key is fully inserted into the switch. 7. If using the electric start, verify the extension cord is properly connected to both the starter outlet and a grounded 120V AC outlet.
T
Tina KennedyAug 6, 2025
What to do if my Craftsman Snow Blower won't throw snow?
- S
  schmidtjoeAug 6, 2025
  If your Craftsman Snow Blower isn't discharging snow, here's what to do: 1. Immediately stop the engine and disconnect the spark plug wire. Clean the chute assembly and the inside of the auger housing using a clean-out tool. 2. If there's a foreign object stuck in the auger, stop the engine and disconnect the spark plug wire. Then, remove the object using a clean-out tool. 3. Check the auger cable and adjust it if necessary, referring to the Assembly section. 4. Inspect the auger belt; if it's loose or damaged, replace it, referring to the Service and Maintenance section. 5. See if any shear pins are sheared and replace them with new ones.
P
Paul GoldenAug 11, 2025
Why is my Craftsman Snow Blower engine running rough?
- G
  Glen BlackAug 11, 2025
  If your Craftsman Snow Blower engine is running erratically, consider the following: 1. Ensure the choke lever is in the 'RUN' position. 2. Check for a blocked fuel line or stale fuel; clean the fuel line and refill the tank with fresh gasoline. 3. Address any water or dirt in the fuel system by running the engine until it stops, then refilling with fresh fuel. 4. If the carburetor is out of adjustment or the engine is over-governed, contact your Sears Parts & Repair Center.
G
Guy MaddenAug 16, 2025
How to fix power loss in my Craftsman 247.881980 Snow Blower?
- P
  Paige RobertsonAug 17, 2025
  If your Craftsman Snow Blower is losing power: * Check that the spark plug wire is connected and tightened. * Make sure the gas cap vent hole isn't blocked by ice or snow; clear it to ensure it's open.
D
Dawn KingAug 21, 2025
What causes excessive vibration in a Craftsman 247.881980 Snow Blower?
- A
  Austin BradyAug 21, 2025
  If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced by a Sears Parts & Repair Center.
A
Ashley PetersAug 27, 2025
Why isn't my Craftsman Snow Blower moving?
- J
  Joseph JonesAug 27, 2025
  If your Craftsman Snow Blower isn't moving on its own, you should: 1. Adjust the drive control cable. Refer to the Service and Maintenance section of the manual. 2. Inspect the drive belt for looseness or damage and replace it if needed. Refer to the Service & Maintenance section for instructions.