EasyManua.ls Logo

Craftsman 247.881733 - User Manual

Craftsman 247.881733
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Sears Brands Management Corporation, Hoffman Estates, IL 60179, U.S.A.
Visit our website: www.craftsman.com
CAUTION: Before using this product,
read this manual and follow all safety
rules and operating instructions.
Operator’s Manual
• SAFETY
• ASSEMBLY
• OPERATION
• MAINTENANCE
• ESPAÑOL
24” SNOW THROWER
Model No. 247.881733
Form No. 769-10906B
(September 8, 2016)

Table of Contents

Questions and Answers

  • B
    Brian ReevesAug 3, 2025
    How to fix a Craftsman 247.881733 Snow Blower when the engine fails to start?
    • M
      Megan ScottAug 3, 2025
      If your Craftsman Snow Blower engine won't start, try these steps: 1. Ensure the choke control is in the CHOKE position. 2. Check that the spark plug wire is connected to the spark plug. 3. Inspect the spark plug; clean, adjust the gap, or replace it if necessary. 4. Make sure the fuel tank has clean, fresh gasoline. 5. Prime the engine as instructed in the Operation section. 6. Verify the safety key is fully inserted into the switch. 7. If equipped with an electric start, confirm the extension cord is properly connected to both the snow blower and a grounded AC outlet.
  • C
    Carol WhiteAug 8, 2025
    Why is my Craftsman 247.881733 Snow Blower engine running erratically?
    • M
      Michael RogersAug 8, 2025
      If your Craftsman Snow Blower engine is running erratically, exhibiting inconsistent RPMs (hunting or surging), consider the following: 1. Ensure the engine isn't running on CHOKE by moving the choke control to the RUN position. 2. Replace stale fuel with clean, fresh gasoline. 3. Drain the fuel tank to remove any water or dirt in the fuel system by running the engine until it stops, then refill with fresh fuel. 4. If the carburetor is out of adjustment or the engine is over-governed, contact your Sears Parts & Repair Center.
  • H
    heidi54Aug 11, 2025
    What to do if my Craftsman Snow Blower fails to discharge snow?
    • C
      Chad DouglasAug 11, 2025
      If your Craftsman Snow Blower isn't discharging snow, here's what to do: 1. Immediately stop the engine and disconnect the spark plug wire. Then, clean the chute assembly and the inside of the auger housing using a clean-out tool. 2. If there's a foreign object lodged in the auger, stop the engine immediately, disconnect the spark plug wire, and remove the object with a clean-out tool. 3. Check and adjust the auger control cable, referring to the Assembly section. 4. If the auger belt is loose or damaged, replace it, referring to the Service and Maintenance section. 5. If the shear pins are sheared, replace them with new ones, referring to the Operation section.
  • D
    Denise CastilloAug 16, 2025
    What to do if my Craftsman 247.881733 won't move?
    • G
      gibbsstephenAug 16, 2025
      If your Craftsman Snow Blower isn't moving forward on its own, check these items: 1. The drive cable may need adjustment. Refer to the Service and Maintenance section for instructions. 2. If the drive belt is loose or damaged, have it replaced by contacting your Sears Parts & Repair Center. 3. A worn friction wheel may be the cause. Replace it by referring to the Service and Maintenance section.
  • D
    danielharrisAug 20, 2025
    Why is my Craftsman Snow Blower losing power?
    • M
      Michael MorrisAug 20, 2025
      If your Craftsman Snow Blower is losing power, check the following: 1. Make sure the spark plug wire is securely connected and tightened. 2. Ensure the gas cap vent hole isn't blocked by ice or snow, and that the vent hole is clear.
  • D
    Donald ReillyAug 25, 2025
    How to stop excessive vibration in my Craftsman Snow Blower?
    • E
      Erica GuerreroAug 25, 2025
      If your Craftsman Snow Blower is vibrating excessively: 1. Stop the engine immediately, disconnect the spark plug wire, and tighten all bolts and nuts. If the vibration continues, have the unit serviced by a Sears Parts & Repair Center.
  • C
    Charles DunnAug 29, 2025
    Why does my Craftsman 247.881733 Snow Blower plow snow instead of blowing it?
    • L
      Linda MoralesAug 29, 2025
      If your Craftsman Snow Blower is plowing snow instead of blowing it, consider these points: 1. Increase ground speed and ensure the engine is running at FULL throttle, especially in wet or slushy snow that is 1-3” deep. 2. Replace any sheared shear pins, referring to the Operation section.

Summary

Warranty Statement

Craftsman Limited Warranty

Details the two-year warranty against defects in material or workmanship.

Additional Lifetime Chute Warranty

Covers the upper and lower chute against defects for the original owner.

Safety Instructions

General Safety Warnings and Precautions

Covers critical safety symbols, operator responsibilities, and general precautions.

Safe Gasoline Handling Procedures

Provides essential safety guidelines for refueling and handling gasoline.

Snow Thrower Safety Symbols

Illustrates and explains various safety symbols found on the machine.

Assembly

Unpacking the Snow Thrower

Instructions for safely removing the snow thrower from its packaging.

Assembling the Handle

Step-by-step guide to attaching the upper and lower handles.

Installing the Chute System

Procedures for attaching the chute base and control head.

Initial Setup and Adjustments

Covers chute clean-out tool, tire pressure, and skid shoe adjustments.

Operation

Snow Thrower Controls Overview

Identifies and explains key controls like shift lever, safety key, and choke.

Engaging Drive and Auger Systems

How to engage the drive system and the auger for snow throwing.

Engine Starting and Stopping Procedures

Detailed steps for starting and stopping the engine using electric or recoil start.

Fueling and Engine Oil Checks

Instructions on how to safely refuel and check engine oil levels.

Service and Maintenance

Snow Thrower Maintenance Schedule

Outlines recommended maintenance tasks and intervals.

Engine Oil Maintenance Procedures

Covers checking and changing the engine oil.

Spark Plug Inspection and Replacement

Guide for checking, cleaning, gapping, and replacing the spark plug.

Lubrication and Component Adjustments

Details lubrication points and adjustments for cables and chute.

Belt and Friction Wheel Maintenance

Instructions for replacing the auger belt and servicing the friction wheel.

Off-Season Storage

Engine Preparation for Storage

Steps to prepare the engine for long-term storage to prevent issues.

Snow Thrower Storage Guidelines

Recommendations for storing the entire unit safely and effectively.

Troubleshooting

Troubleshooting Engine Issues

Addresses common engine starting and running problems.

Troubleshooting Drive & Performance

Solutions for vibration, loss of power, and propulsion problems.

Troubleshooting Snow Discharge Problems

Resolves issues like clogged chutes or plowing instead of blowing snow.

Emission Control Warranty

Emission Warranty Rights and Owner Responsibilities

Outlines owner duties and rights related to the emission warranty.

Emission Control System Warranty Coverage

Details what the emission control system warranty covers and for how long.

Emission Warranty Covered Parts

Lists specific parts covered under the emission control warranty.

Repair Protection Agreement

Craftsman Repair Protection Agreement

Explains the benefits and features of purchasing a repair protection plan.

Craftsman 247.881733 Specifications

General IconGeneral
BrandCraftsman
Model247.881733
CategorySnow Blower
LanguageEnglish

Related product manuals