To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 25332 and is the answer not in the manual?
Learn about safe operation practices, operator responsibilities, and proper use of the equipment.
Prepare the machine and work area to reduce fire risks and prevent injuries before starting operation.
Follow safe operating procedures, including slope limits, starting/stopping, and handling hazards.
Maintain the equipment properly and store it safely to prevent hazards and ensure longevity.
Install the tractor battery, ensuring correct cable connections and safety precautions.
Identify and understand the location, function, and operation of all tractor controls, including lights, throttle, pedals, levers, ignition, and indicators.
Properly fill the engine with unleaded petrol, observing safety warnings and maximum fill level.
Check engine oil level before each run and maintain it between the specified markings.
Ensure cutting unit is in transport position and motion control is in neutral before starting the engine.
Avoid driving on slopes exceeding 5 degrees due to tipping risk.
Perform safety steps like disengaging attachments, setting brake, and removing ignition cable before servicing.
Verify ROS allows reverse with attachments engaged only when ignition is in ROS 'ON' position.
Troubleshoot issues preventing the engine from starting, such as fuel, spark plug, or battery problems.
Learn about safe operation practices, operator responsibilities, and proper use of the equipment.
Prepare the machine and work area to reduce fire risks and prevent injuries before starting operation.
Follow safe operating procedures, including slope limits, starting/stopping, and handling hazards.
Maintain the equipment properly and store it safely to prevent hazards and ensure longevity.
Install the tractor battery, ensuring correct cable connections and safety precautions.
Identify and understand the location, function, and operation of all tractor controls, including lights, throttle, pedals, levers, ignition, and indicators.
Properly fill the engine with unleaded petrol, observing safety warnings and maximum fill level.
Check engine oil level before each run and maintain it between the specified markings.
Ensure cutting unit is in transport position and motion control is in neutral before starting the engine.
Avoid driving on slopes exceeding 5 degrees due to tipping risk.
Perform safety steps like disengaging attachments, setting brake, and removing ignition cable before servicing.
Verify ROS allows reverse with attachments engaged only when ignition is in ROS 'ON' position.
Troubleshoot issues preventing the engine from starting, such as fuel, spark plug, or battery problems.
General| Power Source | Gasoline |
|---|---|
| Voltage | Not applicable |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Engine Type | Gas |
| Cutting Width | 21 inches |
| Cutting Height | 1.25 to 3.75 inches |
