Craftsman 25429 User Manual

instruction manual
Please read these instructionscare-
fully and make sure you understand
them before using this machine.
Anleitungshandbuch
Bitte lesen Sie diese Anleitungen sorg-
fAItigdurch undvergewissern Sie sich,
dab Sie diese verstehen, bevor Sie die
Maschine in Betrieb nehmen.
Manuel d'instructions
Merci de lire tres attentivement le man-
uel d'instructions. Assu rez-vous d'avoir
tout compris avant d'utiliser cetracteu r.
Manual de las instrucciones
Por favor lea cuidadosamente y com-
prenda estas intrucciones antes de
usar esta maquina.
Manuale di istruzioni
Prima di utilizzare la macchina leggete
queste istruzioni con attenzione ed ac-
certatevi di averle comprese bene.
Instructieboekje
Lees deze instructies aandachtig en
zorg dat u ze begrijpt voordat u deze
machine gebruikt.

Craftsman 25429 Specifications

General

Engine Type	4-Cycle
Engine Displacement	140 cc
Cutting Height Positions	6
Mulching Capability	Yes
Power Source	Gasoline
Cutting Width	21 inches

Summary

1. Safety Rules

I. TRAINING

Read instructions carefully, understand controls, and proper use of equipment.

II. PREPARATION

III. OPERATION

Operate in daylight, disengage blades before starting, avoid slopes over 5 degrees.

IV. MAINTENANCE AND STORAGE

2. Assembly

3. Functional description.

Positioning of controls

3. Throttle control

Regulates engine speed and blade rotation speed.

3. Clutch/Brake Pedal

Used for declutching, braking, and starting the engine.

4. Gear shift lever

5. Connection/disconnection of the cutting unit

6. Quick lifting/lowering of the cutting unit

7. Ignition Lock

8. Parking brake

11. Choke control

4. Before starting.

Filling up

Refuel outdoors with pure unleaded petrol, do not overfill, and ensure cap is tight.

4. Oil level

5. Driving.

Starting of motor

Ensure cutting unit is in transport position, disengage attachment clutch, set gear to neutral.

GB Reverse Operation System (ROS)

USING THE ROS

GB WARNING! (about slopes)

GB Switching off the engine

6. Maintenance, adjustment.

Service Precautions

6. Maintenance

6. TO CHANGE OIL

6. Operator Presence System and Reverse Operation System (ROS)

CHECK OPERATOR PRESENCE SYSTEM

CHECK REVERSE OPERATION SYSTEM (ROS)

6. Blades

BLADE REMOVAL

GB) To Check Brake

6. Dismantling of the cutting unit

6. Replacement of drive belt for cutting unit

6. Adjustment of the cutting unit

6. Replacement of drive belt

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT

7. Troubleshooting

8. Storage.