To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 257.796422 and is the answer not in the manual?
Warns about the tool's potential for serious injury including amputation or blindness.
Highlights the danger of flying debris and the need for eye protection.
Defines a 30-foot safety zone around the edger for thrown objects.
Alerts users that the blade continues to spin briefly after the switch is released.
Warns about the risk of electric shock from cutting the power cord.
Emphasizes the importance of following all warnings and instructions for safety.
Covers proper attire, including safety glasses, long pants, and boots.
Advise to operate the unit only when alert and not under the influence of medication.
Instructions on keeping fingers away from the switch when connecting the unit.
Keep hands and feet away from the blade and cutting area.
Use only 120V AC supply and avoid use in rain or wet conditions.
Requires outdoor-rated cords with correct gauge and condition.
Details on polarized plugs and the need for GFCI protection.
Ensure parts are in place, guards are secure, and replace damaged components.
Use only recommended parts and ensure the blade guard is properly attached.
Remove objects from the area and keep children and bystanders away.
Maintain firm footing, balance, keep wheels on ground, and avoid overreaching.
Follow procedures and keep the unit clean. Disconnect power before maintenance.
Carry unit with blade away from body and store unplugged in a safe, dry place.
Briefly describes the purpose of the electric edger.
Provides steps for unpacking the unit and checking contents.
Lists the items included in the product packaging.
Explains the double insulation safety feature and its implications.
Read the manual and gather necessary tools before assembly.
Instructions for connecting the upper and lower tube sections.
Guidance on selecting and connecting the appropriate extension cord.
Ensure all safety warnings and instructions in the manual are reviewed.
Check the entire unit for damage and ensure fasteners are secure.
Ensure blade is not damaged and the blade guard is properly attached.
Key safety points for operating the edger, including attire and alertness.
Ensure the blade guard and blade are properly installed and fastened.
Instructions on setting the unit for edging or trenching modes.
Guidance on safe and effective edging techniques, including area prep and posture.
Instructions on adjusting the depth control wheel for different cuts.
Do not clear material while the motor is running; stop and disconnect power.
Ensure the blade reaches full speed before cutting to prevent stalling.
Troubleshooting steps if the blade does not turn when the switch is activated.
Tips for precise edging along sidewalks and patios.
Guidance for creating wider trenches and managing motor load.
Procedure for cleaning the blade area safely after use.
General safety rules for performing maintenance on the unit.
Instructions for reversing, replacing, and checking the blade for damage.
Ensure all parts are in good condition and replace as needed.
Lists causes and remedies for the blade not operating correctly.
Identifies issues and solutions when the blade spins but doesn't cut.
Troubleshooting steps for improper cutting depth or ground dragging.
Lists optional accessories such as safety goggles, blades, and extension cords.
Details on how to order replacement parts, including necessary information.
Provides phone numbers for repair service, ordering parts, and customer assistance.
General