To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 77237 - 29cc 4 Cycle Gas Edger and is the answer not in the manual?
General| Engine Type | 4-Cycle |
|---|---|
| Engine Displacement | 29 cc |
| Fuel Type | Gasoline |
| Starting System | Recoil |
| Cutting Width | 9 inches |
| Cutting Depth | 2.5 inches |
Explains the meaning of various safety alert symbols used in the manual.
Provides crucial safety precautions specific to operating gasoline-powered lawn edgers.
Details safety symbols and pictographs used in the operator's manual for product identification.
Outlines the terms and conditions of the manufacturer's warranty for the product.
Offers information and benefits of purchasing an extended service plan for the product.
Describes the intended uses and functions of the lawn edger.
Identifies and labels all major parts of the lawn edger through a diagram.
Step-by-step guide for assembling the handle components of the lawn edger.
Details the correct type of oil and fuel required for the engine and proper fueling procedures.
Provides detailed steps for safely starting the lawn edger's engine.
Explains the correct procedure for safely shutting down the lawn edger's engine.
Guides on how to properly hold and position the lawn edger for operation.
Instructions on how to adjust the edger's blade depth for desired cutting results.
Step-by-step process for using the lawn edger to perform edging tasks.
Outlines the recommended maintenance tasks and their frequencies.
Covers blade replacement, belt tension adjustment, and drive belt replacement procedures.
Details oil checks, oil changes, air filter cleaning, spark plug replacement, and spark arrestor cleaning.
Explains how to adjust idle speed and check rocker arm clearances for optimal performance.
Provides instructions for cleaning the unit and preparing it for storage.
Addresses common issues preventing the engine from starting.
Solves problems related to engine idling, acceleration, and power loss.
Diagnoses and resolves issues with the blade not turning or cutting effectively.
Lists detailed technical data for the engine, including type, displacement, and RPM.
Provides technical details for the edger unit, such as weight and cutting depth.
Illustrates all replaceable parts with corresponding item numbers for identification.
Provides a detailed list of part numbers and descriptions for ordering replacements.
